Forklift is in the stage of high energy consumption in loading and unloading operation, reasonable use of loading and unloading, not only can greatly improve efficiency, reduce the cost of use, but also can greatly extend the nondestructive service cycle of forklift and the service life of the whole machine. Forklift maintenance who will do better looking for a technology forklift maintenance service is important, and should be stable, to be able to process within the service life of the forklift maintenance, cannot maintain after the midterm, forklift maintenance service providers do not do, or for other reasons can’t continue to provide us with a forklift service, this situation is very bad, Therefore, it is necessary to find a technical professional and stable forklift maintenance service provider; And the forklift maintenance service provider can provide maintenance plans according to the use of your forklift, some small forklift failures, he should be able to help you deal with. For repeated small faults must have eradication countermeasures, rather than perfunctory, so looking for a long history of forklift maintenance forklift maintenance service providers is necessary.
For the lubricating oil and hydraulic oil of the forklift, the amount of oil should be checked regularly to prevent the poor working condition and serious wear of the forklift. The amount of oil should be added in time. The capacity of battery water should be checked and the battery water should be added in time for the electric forklift, electric stacker and electric truck. Pay attention to the reserve of vulnerable parts for some vulnerable parts, such as seals, to work in a small amount of reserve, in emergency situations, they can determine the fault, such as to replace the vulnerable parts, can deal with their own.
The forklift truck with a lifting height greater than 3 meters should pay attention to the cargo falling from above, and take protective measures when necessary; When working, the door frame should be used as far as possible, and in a small area for before and after the tilt; When filling fuel, the driver should not be in the car, and use the engine to turn off, while checking the battery or fuel tank level, do not start the ignition.
If the rotating parts on the forklift are damaged, the forklift can no longer be operated. Any rapidly rotating parts that have been damaged or altered should be balanced before reuse. In the maintenance operation, use the spare parts produced by the MAIN engine factory or the products of the parts factory approved by the main engine factory; After engine repair, check engine exhaust emission value, qualified before use; Waste oil, waste brake fluid, waste electrolyte and other scrap parts should be specially recycled, classified storage or treatment. In order to avoid environmental pollution, it shall not be disposed of at will; When the forklift truck is installing the fittings, the professional personnel shall carry out according to the specifications of the fittings; When servicing forklift operations, the engine must be turned off before opening the bonnet; Pedals, floors, ladders, platforms and corridors are covered with anti-skateboards. Prevent operators from falling down when walking in greasy areas and causing danger or personal injury; When the forklift fails or the forklift brake fails, it needs to be pulled, please connect it with a hard rod. The total weight of the tractor should not be less than the dead weight of the forklift truck; After maintenance, check whether the nameplates and marks of the main parts are complete.
In order to prevent the occurrence of accidents during maintenance, maintenance or replacement of tires must be carried out by professionals; Do not remove the tire from the rim or remove the rim lock ring before it is completely deflated. Please disassemble, reassemble and inflate the tire according to the operation manual. Reassembled tires must be inflated to standard air pressure in a safety frame.
Post time: Dec-06-2021